Explorer Group 2005 AVANTE, Owner'S Handbook Manual

Page: 32 / 133

Security
Explorer Group 2005 Touring Caravan Handbook
31
• All sensors triggered will result in siren
sounding for 30 seconds,
• Or until reset by pressing the
arm/disarm button.
DISARMING THE SYSTEM.
• Briefly press the (large) arm/disarm
button.
• Double chirp.
• Awning light illuminates briefly on and
off and then on again for 30 seconds.
• LED off.
PANIC ALARM.
• Press and hold the small panic button
on the transmitter for two seconds.
• The siren will sound for thirty seconds,
unless reset by pressing any of the
transmitter buttons.
EMERGENCY DISARM.
• Insert a touch-key briefly into the
socket. The alarm will turn off.
SILENT ARM AND DISARM.
• Press the small button briefly followed
by a press on the arm/disarm button.
• The alarm will arm/disarm without
chirps.
SENSORS
Each caravan alarm is installed with a
Passive Infrared Detector (PIR) and a leg
sensor.
Additional sensors can be purchased
from your dealer to enhance security.
PASSIVE INFRA RED SENSOR.
The wireless PIR sensor will detect
movement in the caravan and transmit a
radio
signal to the alarm module, if the alarm is
on the siren will sound.
LEG SENSOR.
The leg sensor will detect the corner
stabilising leg being raised or lowered
and transmit a radio signal to the alarm.
The leg sensor is fully sealed against dust
and water and has a battery life
expectancy of three years. When the
battery becomes exhausted, the sensor
will need to be replaced.
ENHANCED FEATURES
ARMING THE SYSTEM IN “AT HOME”
MODE.
In the 'at home' mode, any sensor that is
programmed to be isolated, such as the
PIR sensor, will not trigger the alarm.
Other sensors, such as the leg sensor, will
trigger the siren.
Arm as normal followed by a second
press on the arm/disarm button within 2
seconds.
Normal "on" tone followed by "at home"
tone indicating isolation is active.
Settling time of 15 seconds before
responding to triggers.
Armed in the isolation mode will be
indicated by a double flash intermittently
of the LED.
The “at home” sensors will be isolated,
other sensors will trigger the siren for 30
seconds.
ARMING THE SYSTEM IN TEST OR
BUZZ MODE.
In the buzz mode the siren will sound a
short tone when a sensor is triggered
instead of sounding for 30 seconds. It is
advisable to test all the sensors