Exodraft RSG125, Instructions Manual

Page: 5 / 28

1.3 Mechanical assembly
1.3.1 Location of the fan
In the case of a room without a chimney, decide the final location of the appliance. Check that the
fan position on the external wall is acceptable. Mark the centre of the flue exit on the internal wall.
Use this centre to make cutting lines for the flue pipe or silencer using dimensions
for fan RSG125, 150 or 200 as applicable. The hole through the wall should provide
minimum 5 mm clearance between the wall and the flue pipe or silencer. Drill and cut through the
internal and the external wall.
G C
F E B
D
J
A
L
K
H
A B C D E F G H J K L
RSG125 265 250 220 336 320 121 35 280 296 153 157
RSGC150 325 310 240 400 380 125 35 340 360 181 186
RSG150 325 310 240 400 380 146 35 340 360 181 186
RSG200 405 380 275 478 453 196 35 413 438 215 221
1.3.2 Installation of the silencer
If the silencer is shorter ...
... than the wall thickness, use the location brackets supplied with the silencer to secure it in the
wall. It is possible to use two of the holes and screws, which are used to secure the fan.
3001147 RSG-RSGC NO SE UK 150114
UK •
5