Menu sequence and structure •
45
3110086 EHC20 UK 110515
P.3
Unassisted setup
If you decide not to use the setup wizard, you should make the necessary settings in the following order:
•
Menu 9.
Language, page 66
•
Menu 6.15
Time and date, page 65
•
Menu 6.1
Program selection, page 50
•
Menu 4.
Settings, all values, page 48
•
Menu 5.
Protective functions, if changes needed, page 49
•
Menu 6.
Special functions, if further changes needed. page 50
You should now select ”Manual” in the operation mode menu, page 48 in order to test the switch outputs with the
load connected and check the sensor values for plausibility. You can then switch to automatic operation.
Observe the explanations of the individual parameters on the following pages, and check
whether further settings are necessary for your application.
exodraft recommends that you save the configuration on the SD card after the setup.
To save the configuration, you will need to use the “Save config.” function. This can be found in Menu 6.14
(Special functions/SD card).
P.4
Menu sequence and structure
The graphics or overview mode appears when no button has been pressed
for two minutes or if the main menu is exited by pressing ”esc”.
Within this overview, you can scroll through the sensors and relays using
the up and down buttons.
