Maintenance
Maintenance
Note:
Determine the left and right sides of the
machine from the normal operating position.
Maintenance Safety
•
Park machine on level ground, disengage drives,
stop engine, and disconnect spark plug wire. Wait
for all moving parts to stop before leaving the
operator’s position. Allow the machine to cool
before servicing, adjusting, fueling, cleaning, or
storing.
WARNING
Removal or modification of original
equipment, parts and/or accessories may
alter the warranty, controllability, and safety
of the machine. Unauthorized modifications
to the original equipment or failure to use
original Z Turf Equipment parts could lead
to serious injury or death. Unauthorized
changes to the machine, engine, fuel or
venting system, may violate applicable safety
standards such as: ANSI, OSHA and NFPA
and/or government regulations such as EPA
and CARB.
•
If you leave the wire on the spark plug, someone
could accidently start the engine and seriously
injure you or other bystanders. Disconnect the
wire from the spark plug before you perform any
maintenance.
•
Never allow untrained personnel to service
machine.
•
Remove spark plug wire before making any
repairs.
•
Keep all guards, shields, switches, and all safety
devices in place and in proper working condition.
Frequently check for worn or deteriorating
components and replace them with genuine Z
Turf Equipment parts when necessary.
•
Do Not rely solely on mechanical or hydraulic
jacks for support. Use adequate jack stands.
•
Carefully release pressure from components with
stored energy
•
Keep your hands and feet away from moving
parts or hot surfaces. If possible, Do Not make
adjustments with the engine running.
•
Keep all parts in good working condition and all
hardware tightened.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 2 hours
• Check the traction cable.
• Check the broom cable.
After the first 5 hours
• Change the engine oil.
Before each use or daily
• Check the engine oil level.
• Check for loose hardware.
• Check fuel tank filter
• Check the broom shaft shear pin.
• Clean the grass and debris build-up from the machine.
Every 50 hours
• Clean the foam pre-cleaner (more frequently in dusty conditions).
• Check the tire pressures.
• Check the condition of the belts.
Every 100 hours
• Change the engine oil. (May need more often under severe conditions.)
• Grease the broom angle lock pin.
Every 160 hours
• Check the spark plug.
Every 200 hours
• Replace the foam pre-cleaner.
21
Summary of Contents for Z Turf Equipment Z-SWEEP
