Troubleshooting
Problem
Possible Cause
Corrective Action
1. Loose or damaged broom assembly
1. Tighten hardware. Replace broom
assembly or contact an Authorized
Service Dealer.
2. Engine mounting bolts are loose.
2. Tighten the engine mounting bolts.
3. Loose engine pulley or idler pulley.
3. Tighten the appropriate pulley.
4. Engine pulley is damaged.
4. Contact an Authorized Service Dealer.
5. Belt is damaged.
5. Install new belt.
6. Chains are not properly tensioned.
6. See
Drive Chain Tension Adjustment
in Adjustments section.
Abnormal vibration.
7. Material wrapped in bristles or debris
build-up.
7. Clean broom and bristles.
Broom does not stop when drive lever is
released.
1. Broom drive belt out of adjustment.
1. Check broom drive adjustment.
Broom wears out prematurely.
1. Incorrect broom height.
1. Adjust broom height.
Speed selector difficult to move or frozen in
place.
1. Hex shaft needs lubrication.
1. Lubricate hex shaft.
31
Summary of Contents for Z Turf Equipment Z-SWEEP
