13
MODEL EF34
Optional Accessories (continued)
b. Synchronisation of the wall switch (wireless wall control)
•
Turn off the electricity at the electrical panel and wait at least 10 seconds.
•
Reconnect the electricity
•
Within 60 seconds of turning on the power, hold down the LED (orange) button (center button) until
you hear a beep (about 5-10 seconds).
*** Do not press any other button during this process or it will fail ***
•
Once these steps are completed, all functions of the switch will be available.
Reprogramming / resynchronisation with several fans in the same room
If you want to pair several (up to 7) fans on the same remote control
1- switch off the power supply of all fans at the electrical panel for at least 10 sec
2- select the group of fans, power up only the desired fans and within 30 seconds of powering up
again, press and hold the ON/OFF LIGHT button on the remote control
3- Once the synchronization has been completed and detected, you will hear a BEEP SOUND on each
fan of the group which indicates a successful synchronization.
If you want to go back to the initial configuration, (i.e. one fan, one remote control) it is mandatory
to do it fan by fan:
1- switch off the power supply to all fans in the room and then power only the desired fan without
powering any other one.
2- Power up
only
the desired fan, within 30 seconds of powering up, hold down the LED ON/OFF
button for at least 10 sec. Make sure you do not press any other button, otherwise the process will
fail.
NB
: A motor can have up to 2 remote controls. If you wish to pair a second remote control - repeat
the same operation with the second remote control.
