OmniCure® AC2 Series
UV Curing Solutions
http://www.excelitas.com/omnicure
Excelitas Canada Inc. 2015
All rights reserved
035-xxxxxR, rev.1
9
035-00589R Rev5
5
Mounting the UV Head
**WARNING**
Do not block the air intake or the exhaust fans for the UV LED module's cooling
system. Ensure that both intake and exhaust vents located on the LED heads have
at least 2 inches (5cm) of clearance to allow sufficient air flow.
The UV LED Head weights can be found in
Section 10.2
The UV LED Head has four mounting holes on the back of the unit, M4 X 7mm deep. Refer to Figure 3.
For optimal performance, do not obstruct the air exhaust and air intake on the unit.
For detailed mechanical drawings, please refer to:
http://www.excelitas.com/Pages/Product/OmniCure-AC-2-Series.aspx
**CAUTION**
The threaded mounting holes incorporate a blind configuration; ensure that the
appropriate length of mounting hardware is used. Attempting to install over-
length mounting screws could damage the threaded mounting holes and internal
components.
