Safety
English
8
Further safety instructions
The pipe saw must never be used in the following
cases, if:
There is water or another liquid, explosive gases or
poisonous chemicals inside the pipe to be cut.
The power switch is faulty.
The power cable is faulty.
The blade is bent.
The blade is dull or in poor condition.
The plastic components are cracked or have parts
missing.
The gripper unit is not properly tightened around the
pipe or if it is warped.
The blade guard cover or moving blade guard has
been damaged or removed from the machine.
The locking mechanisms do not work properly
(UNLOCK - SWITCH).
The pipe saw has become wet.
When you use the saw, the following factors shall
be considered:
Fasten the pipes to be cut properly so that the blade
is not clamped between the ends of the pipes.
Make sure that the pipe to be cut is empty.
Make sure that the pipe is installed correctly.
Make sure that the diameter and thickness of the
blade is suitable for the saw and that the blade is
suitable for rotational speed selected
Never use axial friction force to stop the blade, let it
stop freely.
Check the parts of the blade protection.
Never apply excessive force when using the
pipecut.
Never use the pipecut to lift the pipe when fixed on
the pipe.
Avoid excessive load on the electric motor.
Always follow safety and operation manual and
applicable regulations.
Description of the work
Read all manuals and warnings carefully. If warnings
and instructions are not complied with, the risk of
electric shock, fire and/or severe damage to life may
occur.
Intended Use
PipeCut 360 INOX Series 460 INOX Series
PipeCut 360 INOX Series / 460 INOX Series pipe
saw is intended for use as a pipe fitter’s tool at the
job site.
PipeCut 360 INOX Series / 460 INOX Series can
only be used to cut round pipes, with a diameter of:
360 INOX Series: 75 mm–360 mm (3"–14")
460 INOX Series 100 mm–460 mm (4"–18")
Maximum wall thicknesses:
Steel 20 mm (0.8"), 230V
12mm (0,5”), 120V
Plastic 50mm (2”)
PipeCut 360 INOX Series / 460 INOX Series pipe
saw can be used to cut all normal pipe materials,
such as steel, stainless steel, cast/ductile iron,
copper, aluminum and plastic.
See the cutting depth table on page
16.
PipeCut 360 INOX Series / 460 INOX Series pipe
saw is not intended for use in industrial production.
Use pipe holders to support the pipe being cut
