Intended use
Use and operation solely with the following machines
14
099-005664-EW501
22.09.2021
3.2.3 Welding in environments with increased electrical hazards
Power sources with this marking can be used for welding in an environment with increased
electrical hazard (e.g. boilers). For this purpose, appropriate national or international regulations
must be followed. The power source must not be placed in the danger zone!
3.2.4 Service documents (spare parts and circuit diagrams)
WARNING
Do not carry out any unauthorised repairs or modifications!
To avoid injury and equipment damage, the unit must only be repaired or modified by
specialist, skilled persons!
The warranty becomes null and void in the event of unauthorised interference.
• Appoint only skilled persons for repair work (trained service personnel)!
Original copies of the circuit diagrams are enclosed with the unit.
Spare parts can be obtained from the relevant authorised dealer.
3.2.5 Calibration/Validation
An original certificate is enclosed with the product. The manufacturer recommends calibration / validation
at intervals of 12 months.
3.3 Use and operation solely with the following machines
A suitable wire feed unit (system component) is required in order to operate the welding machine!
The following system components can be combined:
Power source
Taurus XQ 355 Synergic
Taurus XQ 405 Synergic
Taurus XQ 505 Synergic
Wire feed unit
Drive XQ HP
Drive XQ LP
Drive XQ EX
Drive XQ DV200
Welding torch cooling unit
Cool 50-2 U40
Cool 50-2 U42
Transport vehicle
Trolly 35-6
Trolly XQ 55.5
Trolly 55.6
Trolly 55.6 DF
