Welding procedure
TIG welding
099-00T400-EW501
21.10.2016
53
Display
Setting/selection
Expert menu
Slope time (main current to secondary current)
Slope time (main current to secondary current)
Slope time (main current to secondary current)
Slope time (main current to secondary current)
Amplitude balance
activArc parameter
Parameter also adjustable after TIG activArc welding is activated.
AC commutation optimisation
> see 4.1.17 chapter
------- Function enabled
------- Function disabled (ex works)
Filler wire process (cold/hot wire)
------
filler wire activated
------
filler wire deactivated (factory setting)
Hot wire process (start signal for hot wire power source)
------- Function enabled
------- Function disabled (ex works)
Wire/pulse function (wire feeding behaviour when using pulsed TIG welding)
Wire feeding can be disabled during pulse pauses (not the case for automated
pulsing or kHz pulsing).
------- Function disabled
------- Function enabled (ex works)
Filler wire diameter (manual setting)
Setting the wire diameter between 0.6 mm to 1.6 mm.
The character "d" preceding the wire diameter on the display (d0.8) indicates a pre-
programmed characteristics (correction operating mode "
KORREKTUR”).
If there is no characteristics for the selected wire diameter, the parameters have to be set
manually (manual operating mode “MANUELL“).
To select the operating mode
> see 4.3.1.2 chapter
.
Wire return
• Increase value = more wire return
• Decrease value = less wire return
Simultaneous AC welding on both sides, synchronisation types
------- Function disabled (ex works)
------- Synchronisation via mains voltage (50 Hz/60 Hz)
Ignition type (TIG)
------- HF start active (ex works)
------- Lift arc ignition active
