Design and function
MIG/MAG welding
099-004846-EW501
8.01.2014
47
5.7.11
Main program A mode
Operating
element
Action
Result
Display
n x
Change welding data display over to program
display.
(LED
PROG
is on)
Select program number.
Display example: Program "1".
n x
Select program sequence parameter
"Main program (P
A
)".
(LED is on)
Set wire speed.
(Absolute value)
Set arc length correction.
Display example: "-0.8 V" correction
(Setting range: -9.9 V to +9.9 V)
1 x
Select "Dynamic" program sequence parameter.
(LED
is on)
Set dynamic. (Setting range 40 to -40)
40:
Arc hard and narrow.
-40:
Arc soft and wide.
NOTE
Changes to the welding parameters can only be made when the key switch is in
position "1".
5.7.12
MIG/MAG automatic cut-out
NOTE
The welding machine ends the ignition process or the welding process with an
• ignition fault (no welding current flows within 5 s after the start signal)
• arc interruption (arc is intrerupted for longer than 5 s)
Summary of Contents for Phoenix Expert drive 4L M3.70
