Evoqua Wallace&Tiernan 50-200 Series, Manual

Page: 17 / 111

WT.050.200.001.UA.IM.0814
50-200 EVAPORATOR FOR CHLORINE
6
EVOQUA W3T98237
WARNING: TO AVOID POSSIBLE SEVERE PERSONAL INJURY OR DAM-
AGE TO EQUIPMENT, READ AND UNDERSTAND THIS ENTIRE PREPARA-
TION PROCEDURE AND FAMILIARIZE YOURSELF WITH THE CHLORINE
HANDLING MANUAL BEFORE PERFORMING ANY WORK. BE SURE THE
CHLORINE SUPPLY REMAINS OFF UNTIL INSTRUCTED TO TURN IT ON.
2.1 General
NOTE: Reference to optional equipment may be disregarded if such equip-
ment is not a part of your installation.
WARNING: WHEN HANDLING HAZARDOUS MATERIAL, IT IS THE RE-
SPONSIBILITY OF THE EQUIPMENT USER TO OBTAIN AND OBSERVE ALL
SAFETY PRECAUTIONS RECOMMENDED BY THE MATERIAL MANUFAC-
TURER/SUPPLIER.
The Series 50-200 Evaporator is shipped completely assembled and ready for
installation. For the location of the various evaporator components, see Dwg.
50.200.110.010.
2.2 Unpacking and Base Mounting
a. Unfasten and remove shipping crate.
b. If a back cover (outdoor option) was provided, remove it. Loosen and re-
move the bolts located at the top of the evaporator where the enclosure
sides are fastened together.
c. Loosen the black, quarter-turn screws in the side panels of the enclosure.
NOTE: Do not attempt to remove the quarter-turns screws as they are retained
on the reverse side of the panel by grommets.
d. Remove the side panels. Do not replace them until the evaporator is ready
for operation.
e. Remove top cover and pipe trim.
f. Attach two lifting hooks, each with no less than 1/2-ton capacity rating, to
the lifting brackets that extend out a few inches from the gray insulation
ring.
g. Chain the lifting hooks together to a hoist or crane.
WARNING: TO AVOID SEVERE PERSONAL INJURY, LIFT THE EVAPORATOR
BY A CRANE HAVING NO LESS THAN A ONE-TON CAPACITY RATING. LIFT
EVAPORATOR ONLY IN THE MANNER SHOWN ON DWG. 50.200.110.030.
!
!
!