
®
12
www.evolutionsteel.com
GETTING STARTED - PREPARATION
WARNING: Always disconnect the saw from the
power source before making any adjustments.
This saw is equipped with an approved mains lead and plug for its
intended country of use. Do not alter or modify the mains lead.
INSTALLING/REMOVING A BLADE
WARNING: Only use genuine Evolution blades which
are designed for this machine.
Ensure that the maximum
speed of the blade is compatible with the machine.
Only
perform
this operation with the machine disconnected from
the power supply
.
Note:
It is recommended that the operator considers wearing
protective gloves when handling the blade during installation or
when changing the machines blade.
• Place saw on a level, secure surface.
• Remove the chip collector from the machine by undoing the
(2) large thumb screws.
(Fig. 1)
Note:
The chip collector thumb screws are ‘captive’ and cannot
be removed from the machine.
• Lock the machine arbor by engaging the arbor lock.
(Fig. 2)
• Using the supplied Hex Key loosen and remove the arbor
socket headed screw and outer blade drive flange.
(Fig. 3)
Note:
The socket headed arbor screw has a right Hand thread.
• Remove the saw blade, leaving the inner blade flange in it’s
service position.
• Thoroughly clean inner and outer blade drive flanges and blade
mounting surface before installing a new blade.
Fig. 1
Fig. 2
Fig. 3