Evoca Group Snakky SL, Installation, Use And Maintenance Manual

Page: 24 / 64

20
© by NECTA VENDING SOLUTIONS SpA 0303 204-00
S
TATISTICS
Data on the machine operations is stored in both general
counters and relative counters, which can be reset without
losing total data.
PRINT
Connect an RS232 serial printer having a Baud rate of
9600, 8 data bit, no parity, 1 stop bit to the serial port
located on the push-button board to print all of the statis-
tics, and namely:
Total
- counter by single selection;
- counter by time bands;
- failure counter;
- photocell errors;
- motor errors;
Relative
- counter by single selection;
- counter by time bands;
- failure counter;
- photocell errors;
- motor errors;
The hardcopy printout will also contain the machine infor-
mation, and namely:
- date/time of print
- machine name
- software version
- operator code
- machine code
- Installation date.
To connect the printer, do as follows:
- press the confirm print key “ ”, displaying the mes-
sage “Confirm?”;
- connect the printer before confirming;
- press the confirm key “ ” to start printing.
DISPLAY
When pressing the confirm key “ ” the data described in
the paragraph “Printing the statistics” is sequentially dis-
played.
RESET STATISTICS
Statistics can be reset for counters globally (all types of
data) or selectively for:
Total
- selections
- failures
- photocell errors;
- motor errors;
Relative
- selections
- failures
- photocell errors;
- motor errors;
Press the confirm key “ ”, and the message “Confirm?”
starts blinking.
Press the confirm key “ ”, the message “Working” is
displayed for a few seconds and all statistics are reset.
N.B.: when resetting the total statistics also the relative
statistics are reset.
TEST
SELECTIONS
This function is used to simulate the normal dispensing of
products without inserting any money.
To check the functioning of the motors press the selection
keys.
MOTOR TEST
It activates all motors in a sequence.
AUTOTEST
A function to check, in a semiautomatic manner, the
correct operation of some devices is implemented in the
software.
Some checks occur automatically, others need the manual
operation of the monitored component; press key “ ” to go
to the next check.
The monitored devices are:
“Keypad”
Press the key of the master machine numeric keypad
requested on the display; if it works correctly the request
for the next key is presented.