EVOC M60 Series, Manual, Page: 36 / 124

Debugging
M60 SERIES · 27 ·
Pin setup Mode selection
COM3 COM4 COM5 COM6
RS-232
(Default)
RS-422 RS-485
JP1 JP4 JP7 JP10 1-2 3-4 5-6,7-8
JP2 JP5 JP8 JP11 1-3,2-4 3-5,4-6 3-5,4-6
JP1 ～ JP12
JP3 JP6 JP9 JP12 1-3,2-4 3-5,4-6 3-5,4-6
Note: 1. Mode selection for COM1,COM2 is carried out under BIOS.
(For details of M60-E, please refer to Page 41,42; for details of M60-H, please refer to
Page 60,61)
2. If COM1
～
COM6 are to be set to automatic flow control function of RS-485
mode, it needs to be set under BIOS.
(For M60-E, please refer to Page 42; for M60-H, please refer to Page 60,61)
5.2.10 GPIO Port
Pin Signal Name Pin Signal Name
1 D1 2 D2
3 D3 4 D4
5 D5 6 D6
7 D7 8 D8
GPIO
(pitch: 3.81mm)
9 GND 10 VCC
Note: The factory default status is high level
（
5V
）
,and the voltage range of
input/output signal is 0-5V.