3067VIP10G Series User Manual
JPEG2000 Advanced Compact Multi-Image Display Processors
Page 26
Revision 0.1
6.1.1. Control Port
IP Address for Control Port :
This parameter allows the user to set the IP Address for Control Port .
Netmask/Subnet Address for Control Port :
This parameter allows the user to set the
Netmask/Subnet for Control Port .
Gateway Address for Control Port :
This parameter allows the user to set the Gateway Address for
Control Port1.
6.1.2. Data Port Control for SFP Ports
IP Address for Data Port :
This parameter allows the user to set the IP Address for Data Port .
Netmask/Subnet Address for Data Port :
This parameter allows the user to set the Netmask/Subnet
for DataPort .
Gateway Address for Data Port :
This parameter allows the user to set the Gateway Address for Data
Port .
Received Optical Power :
This parameter indicates the received optical power status on the SFP-Rx
and is measured in 1dBm units. Range for this value can be from -128dB to 128dBm.
Port Link Status:
This parameter will indicate the status of the port link as either ‘Up’ or ‘Down’.
Port Link Info:
This parameter displays link status for Port Monitor (i.e. speed, duplex)
Received Link Errors:
This parameter displays the link errors received
Received Data Ethernet Total Bitrate:
This parameter indicates the bit rate received on Ethernet Port
1 in kbps. Range for this value can be from 0 to 1000000.
Transmitted Data Ethernet Total Bitrate:
This parameter indicates the bit rate transmitted on the
Ethernet Port in kbps. Range for this value can be from 0 to 1000000.
Clear Stats:
This parameter allows the user to reset the Ethernet monitored statistics.
6.1.3. Temperature
FPGA Top Temperature:
This parameter allows the user to verify the top of the FPGA module
temperature. This value is represented in degrees Celsius.
FPGA Bottom Temperature:
This parameter allows the user to verify the bottom of the FPGA module
temperature. This value is represented in degrees Celsius.
CPU Temperature:
This temperature allows the user to verify the current temperature of the CPU. This
value is represented in degrees Celsius.
System Reboot:
This parameter enable a soft system reset. To allow for a power cycle of the device a
manual reboot must be performed.
