7
If a booster pump is required, refer to Figure 4. Assemble a male elbow fitting to the pump
inlet and a male connector fitting to the pump outlet. Attach the pump to the mounting plate
with the hardware provided. Attach the pump with mounting plate to the backplate with the
hardware provided. The flow arrows on the pump head should be pointing up to prevent air
entrapment. Attach a length of tubing from the pump outlet to the inlet shut-off valve.
BOOSTER
PUMP
#10 NUT (8)
1/2Ø X 1"
SPACER (4)
#10 X 1-1/2" SCREW (8)
#10 WASHER (16)
MOUNTING PLATE
Figure 4
5. Refer to Figure 5 for a sample general arrangement. Use this as a guideline for determining
valve location, tubing/pipe sizes, etc.
Note:
This is only a guideline and your installation may include fewer or greater number of
components than outlined.
6. The cartridge usage monitor requires two AAA batteries.
Do not install the batteries until
installation is completed and the system is ready to put into service.
7. Connect the water to be treated to the system inlet shut-off valve on systems without a
booster pump or to the booster pump inlet on models with a booster pump.
Summary of Contents for MRS-200
Page 19: ...19 Replacement Parts...
