63
Rev02132016
ThermalRite Blast Chiller Easy Touch Screen Manual
process during all the cycle, with
Air Temperature
and
Fan Speed
always being the
same value.
5.4.
Cycle Graph and other functions
For either a
Pre-programmed
,
Custom
or
Manual
cycle the graph will show the
Air
Set Temperature
, the actual cavity
Air Temperature
and the
Product Probe
Temperature
during a
Chilling
or
Freezing
cycle. The
Timer
will count down until it
reaches the cycle set time or will count up, when using the
Product Probe
, until the food
target temperature is reached and will then switch to the
Hold
mode. The cycle can be
stopped at any time by pressing the
Stop
button. If the door(s) are opened, the fans and
compressor will turn off. The compressor has a
1-minute
delay on start up.
The graph can chart the various probes and can be customized to the user’s choice. In the
example below, the
4
sensors of the
Product Probe
(yellow, blue, black and green) are
on the top of the graph and the evaporator sensor (red) is on the bottom of the graph.
Notice there is no
End Cycle Time
indicated, as the
Product Probe
is being used.
At any time while running a cycle, touch anywhere on the graph and this screen will
appear. It allows the user to select which temperature value will be charted in the graph
by enabling or disabling the
Green Checkmarks
on the left side tabs. The
Product
Probe
and the cavity
Air Temperature Probe
are enabled. Although you can chart
4 Product Probe Sensors
Evaporator Sensor
