Everglades 320 EX, Owner'S Manual, Page: 65 / 170

65
Electrical System
Underwater Lights
Activates the lights in the transom below the
waterline.
Lower Docking Lights
Activates the lights in the hull on each side of the
bow that illuminate the area in front of the boat
for better visibility while docking at night.
Flood Lights
Activates the overhead lights at the rear of the
hardtop that illuminate the aft cockpit.
P Vent Open
A momentary switch that activates the electric
actuator that opens and closes the port windshield
panel that provides ventilation for the bridge deck/
cockpit.
C Vent Open
A momentary switch that activates the electric
actuator that opens and closes the center wind-
shield panel that provides ventilation for the bridge
deck/cockpit.
S Vent Open
A momentary switch that activates the electric
actuator that opens and closes the starboard
windshield panel that provides ventilation for the
bridge deck/cockpit.
W/S Wiper
A three position switch that activates the wind-
shield wipers. Press the lower position to turn the
wipers off. Move the switch to the center position
Main Accessory Switch Panel, Battery Switches and Emergency Parallel Switch in Helm
to activate only the driver side wiper. Press the
upper position to activate all three wipers.
W/S Washer
a monetary switch that activates the windshield
washer. Press and hold the switch to activate the
washer release the switch to stop the washer.
Notice:
The fresh water system must be activated
for the windshield washers to work.
House
Remotely activates the House battery switch. A
red LED light in the switch glows when the bat-
tery switch it controls is activated. Slide the label
down and press the top of the switch to activate
the indicated battery switch. Slide the label up
and press the bottom of the switch to turn the
indicated battery switch off. The red light may
not turn off immediately or will slowly fade out if
there are no loads present on the system.
Engine 1
Remotely activates the Port Engine battery switch.
A red LED light in the switch glows when the bat-
tery switch it controls is activated. Slide the label
down and press the top of the switch to activate
the indicated battery switch. Slide the label up
and press the bottom of the switch to turn the
indicated battery switch off. The red light may
not turn off immediately or will slowly fade out if
there are no loads present on the system.