Page | 3
AP1004WRe Installation Guide
Chapter 2 : Installing AP1004WRi
This section provides information required to install AP1004WRi Wireless Access Point.
Third-Party Mounting System Installation
AP1004WRi Wireless Access Point has two sets of mounting holes at the bottom of the chassis for
attaching third-party mounting systems:
•
The inner set of mounting holes are 75 mm apart in both the horizontal and vertical directions and are
tapped with a M4 x 0.7 mm thread pattern to a depth of 10 mm.
The AP1004WRi installation must be performed by certified technicians only and
in compliance with all local/state/federal safety requirements and building codes.
Proper grounding and surge protectors may be required in some installations.
The network coverage depends on the location and position of the AP1004WRi.
The installer or user assumes all liabilities unless the installation methods are explicitly
stated in a warranty agreement between Tembo Systems, Inc. and the third-party
installer.
Summary of Contents for AP1004WRi
Page 2: ...Release Number 1 4 ...
