Page | 8
AP1004WRe Installation Guide
Configuring AP1004WRi to Work with Discovery Protocol
In some cases, a POE+ Ethernet switch requires a Discovery Protocol such as LLDP and CDP to request
additional power above the 15.4 W PoE PSE limit. In such cases, the POE+ PSE source must be configured
to override the Discovery Protocol and force the PoE+ PSE source to provide at least 22.5 W of PoE+
power.
Perform this procedure to configure the AP to work with Discovery Protocol.
1. In the BaseCamp
Access Point
menu, set the
Passive POE
selection to flag the AP1004WRi Wireless
Access Point to ignore the POE+ status.
The AP1004WRi Wireless Access Point automatically reboots when the new
Passive POE
selection is
saved. All the AP1004WRi hardware resources are available after rebooting the AP1004WRi.
Use extreme caution.
This is a manual mode of operation. There is no action taken by
the AP1004WRi, if PoE+ power is interrupted. Even a single port losing PoE+ power
may result in an overload on the port.
Summary of Contents for AP1004WRi
Page 2: ...Release Number 1 4 ...
