42
The PIN status of the current card, i.e., enabled or disabled, will be displayed as
shown below. Press
ENT
to toggle between two statuses. Press
to exit.
When PIN is set enabled, press
or
to set PIN as shown below. Enter 4-
digit PIN and press
ENT
to confirm.
The default PIN is 6 zeros. The duplicated PIN in the system is not allowed. If the
typed PIN has existed in the system, the system will prompt that the PIN is
duplicated.
Anti Passback (APB) Setting
EverAccess access control system features the Anti Passback (APB) function on each
card. If APB is enabled, cardholder must pass the door in the alternating enter/exit
order. That is, if the card is swiped to enter the door, then next time the card can only
be allowed to exit that door. If cardholder attempts to enter the same door again
without first swipe the card to exit the door, access is denied and the door will not
open.
At the following submenu, press
ENT
to enter Anti Passback setting:
The APB status of the current card, i.e., enabled or disabled, will be displayed as
shown below. Press
ENT
to toggle between two statuses. Press
to exit.
Note: Anti-Passback (APB) is an access control function whereby a cardholder is
prevented from “passing back” his card to another person to gain entry into the same
area twice, without leaving. Facilities are typically fitted with both Entry and Exit
readers when Anti-Passback is implemented. A cardholder must alternate usage
between entry and exit readers. If the cardholder attempts to pass through an entry
Set PIN
______
PIN Setting
Anti-Passback
Setting
CLR
CLR
PIN Enabled
[ENT] to Toggle
PIN Disabled
[ENT] to Toggle
APB Enabled
[ENT] to Toggle
APB Disabled
[ENT] to Toggle
Summary of Contents for EFC-02-1A
Page 73: ...65 Notes...
Page 74: ......
