14
15
Dial the required dose
Dial the required dose by turning the dosage wheel clockwise. Correct
the dose by turning in anti-clockwise direction. Check the dialed
dose by looking vertically from above and not at an angle onto the
display, so that the numbers are clearly identified.
Note: Each “-“ marking on the dose dialer represents 0.1 mg of medi-
cine. You will hear a click for each increment you dial. Do not rely on
counting these clicks to measure the correct dose.
Safety stop
The medication dose that can be set on the D-
mine
®
Pen is limited to
the amount remaining in the cartridge. If the amount of medicine left
in the cartridge is no longer sufficient for the desired dose, the dosa-
ge wheel cannot be turned any further in a clockwise direction.
SETTING THE DOSE
1
Please refer to the Product Information of the pharmaceutical
product and use the injection technique as recommended
by your physician and/or your ANSSER nurse. Press the
push-button in fully for injection. Hold the push-button fully
down during medication discharge.
2
After the medication has been completely discharged, wait for
6 seconds and then pull out the pen needle slowly. You may
either keep the push-button pressed or release it during the 6
seconds.
INJECTION
3
Check that the display is at the “0.0” position to confirm full
dose delivery.
Note:
You can interrupt the injection by releasing the push-button. The
remaining amount of medicine not delivered can be seen on the display
and can be injected by pressing the push-button again.
