User Guide System Mode
38
When a Parameter Control Knob designator is displayed (KNOB0… KNOB9), pressing the Left
Footswitch will display [MIN VAL]. Turn the associated Parameter Control Knob to set the
minimum value. For example, if KNOB0 was selected, turn the Mix Control Knob to set the
minimum value. The Billboard displays the knob value while you’re turning the parameter
knob and times out to display the selected [MIN VAL] when the knob is idle.
Push the Left Footswitch again to set the maximum value for the selected Parameter Control
Knob. The Billboard will display [MAX VAL]. Turn the associated parameter knob to adjust the
maximum value. The Billboard displays the knob value while you’re turning the parameter
knob and times out to display the selected [MAX VAL] when the knob is idle.
The parameters controlled in this mode are system-wide and will apply to all Presets. For
example, you could assign an Aux Switch to Decay (KNOB1) with [MIN VAL] set to 1 sec and
[MAX VAL] set to 2 sec. Pressing the switch will toggle between these two decay values. If
another Effect or Preset is chosen, the Aux Switch will affect the parameter controlled by
KNOB1 for the currently loaded effect.
Note: When a Preset is loaded, the switches assume the MIN VAL for the assigned
parameters. Pressing the switch for the first time after a Preset load, will toggle the parameter
to MAX VAL.
To Setup the External Control Source
Now that you have selected what the Aux Switch controls, press the Right Footswitch to
select one of three Aux Switches to perform the function. There are two ways to select the
Aux Switch - Manual Select or Learn Mode. For Manual Select simply turn the Encoder to
choose the Aux Switch. The choices are:
TIP - Aux switch jack tip connection
RING - Aux switch jack ring connection
T+R - Aux switch jack tip + ring connection
To use the Learn Mode to select the external control source, press the Right Footswitch again.
“LEARN” is displayed prompting you to press an Aux Switch for automatic assignment. Press
the Right Footswitch again to exit LEARN mode and revert to manual source selection.
Press the Left and Right Footswitches to toggle between Source and Destination to make as
many assignments as you wish.
The default settings for Aux Switch control are as follows:
[BYPASS<>TIP]
[HOTSW<>RING]
[TAP<>T+R]
The other Aux Switch Control destinations ([PRE+], [PRE-], [PLY/PRE], [KNOB0]…[KNOB9],
FS1, FS2, FS3, PEDAL) are unassigned as indicated by [---].
Note: It is possible to assign the same Aux Switch to multiple destinations. In other words,
you could assign [TIP] to control Bypass AND Tap AND HotSwitch AND a parameter, etc. The
ability to have the same switch control multiple functions can be very useful. However, you
should keep in mind that, if you have previously assigned a Switch to a control destination,
you may want to clear the assignment before setting up a new assignment.
When done, Press the Middle Footswitch to go to the top level System menu.
Summary of Contents for Space
Page 2: ......