Evenflo Triumph Advance, Owner'S Manual

Page: 15 / 25

SecureRight™ Quick Connector™
LATCH is a system for attaching the child restraint to
your vehicle seat. It is to be used in place of your
vehicle’s seat belts, and can be used in vehicles with
LATCH anchors. Your vehicle owner’s manual may refer
to this system as ISOFIX.
• ONLY use for securing child restraint to lower LATCH
anchor points.
• ALWAYS read and follow exactly the instructions that
accompany your vehicle and child restraint.
• NEVER attach two hooks to one vehicle lower
anchor point.
• DO NOT use the vehicle seat belts to install a child
restraint when using the LATCH system.
• This LATCH system is intended to be used ONLY as
described in these instructions. Serious injury or death
may result from misuse.
• When not in use, the LATCH harness and hook should
be securely clipped onto the base of the child restraint.
Keep out of reach of children.
• ALWAYS be sure that the LATCH hook is fully
engaged onto the LATCH anchor point by pulling hard
on the LATCH harness. If it is not totally engaged, the
LATCH system will not secure your child restraint.
Serious injury or death may result.
• In addition to these instructions, read and follow your
vehicle owner’s manual regarding installation of child
restraints and LATCH. If there is a discrepancy, follow
your vehicle owner’s manual.
WARNING
Forward-facing
Installation Using LATCH
Installation:
For
ward-facing
27
26
Know Your LATCH
Hook
Adjuster
Harness
Adjuster
Clip
Harness
The LATCH harness that comes with your child
restraint will be one of the two types below.
NOTE: Refer to your vehicle owner’s manual for the
location of the tether anchor bracket in your vehicle.
Older vehicles may not come equipped with anchor
bracket hardware. Check with your vehicle dealer.
If you have questions regarding tether anchors which
are not addressed by the vehicle owner’s manual, or
answered by an authorized dealer/vehicle manufacturer
call Evenflo’s ParentLink at 1-800-233-5921.
Attach tether hook
G
to the tether anchor bracket
H
in your automobile.
Pull the end of the strap
I
to tighten. Remove all
slack in the strap.
• To avoid a strangulation hazard, you MUST tightly roll
or fold excess tether strap and secure with the strap/
rubber band.
• Attach the tether hook to the storage clip when not in
use. This will keep an unused tether from hitting some-
one during a crash.
WARNING
9
I
G
H
After adjusting the top tether strap, you may have
excess strap; DO NOT cut it off. If you do, it may not
be long enough to use in another vehicle. Instead,
tightly roll up the excess tether strap and place the
rubber band around the bundle .