Evenflo Triumph Advance, Owner'S Manual

Page: 12 / 25

21
20
5
After the LATCH harness
E
has been correctly inserted,
it will appear as shown above. NOTE: Make sure the
adjustment buckle
F
is on the correct side of the child
restraint, as shown.
F
E
Refer to your vehicle owner’s manual to locate the
lower anchors on your vehicle seat.
Attach the left hook
A
, or clip
B
, to the left anchor
G
,
and the right hook to the right anchor. DOUBLE
CHECK that each LATCH hook or clip is fully engaged
by pulling hard on the LATCH harness.
6
A
G
Using your full weight, push the child restraint firmly
into the vehicle seat while pulling up on the LATCH
harness to tighten.
The LATCH harness must be as tight as possible.
If you can move the child restraint more than 1 inch
(25 mm) forward or side-to-side at the belt path
H
,
the LATCH harness is not tight enough. You will need
to try again, or find another location for your child
restraint.
To remove the LATCH harness, go to page 37.
7
H
➚
B
G
Make sure that when you connect a Quick Connector™
clip to an anchor, the word “SafeGuard
™
” is always
facing out and in the upright position, as shown above.
Correct Incorrect
Installation:
Rear-facing