9
ESW4 Closed Circuit Coolers
Mounting Fan Screens
12’ (3.6m) and 14’ (4.2m) wide units will be shipped with the fan screens in the basin. Under these circumstances use the following
procedures to mount the fan screen on the discharge cylinder.
WARNING: DO NOT WALK ON THE FAN SCREENS
AT ANY TIME!
1. Lay both halves of the fan screen on the ground. Join the
two screen halves with wire clips (Figure 11). There should
be 4 wire clips on each side of the fan screen for 12’
(3.6m) and 14’ (4.2m) wide units. Space the wire clips
evenly across the radius of the fan screen as shown in
Figure 12.
2. The fan screen is supported from underneath by an “X”
shaped support frame. Set the support frame across the
top of the discharge cylinder (See Figure 13), and fasten to
cylinder with 3/8” (10mm) bolts.
3. Place the fan screen on top of the support frame and
discharge cylinder. Each half will be tagged to match
markings on the cylinder. Align the eyelets of the fan
screen with the holes on the perimeter of the discharge
cylinder.
4. At each hole, attach the fan screen to the discharge
cylinder as shown in Figure 14.
5/8" (16mm) FLATWASHER
1/2" (13mm) BOLT
1/2" (13mm) FLATWASHER
FAN SCREEN
1/2" (13mm) LOCKWASHER
1/2" (13mm) HEX NUT
Figure 12
– Wire Clip Spacing
WIRE
CLIPS
FAN SCREEN
SUPPORT
FAN
CYLINDER
Figure 14
– Attaching Fan Screen to Cylinder
Figure 11
– Wire Clip Arrangement
U-BOLT
ASSEMBLY
Figure 13
– Support Frame Installation
