Wiring Diagrams V22.3
12
EVA Experience Controller PCB
| Settings
Article: SP-ECA-PRO / EVA-ECA-PRO
Stream controller V2
Controlling EVA lighting by APP
Basis configuration is control by APP + piëzo unit
Rotary switches at 000 (factory settings, mastermode)
Slow down and speed up in 5% increments
See wiring schematic Piezo3 to SP/EVA-ECA-PRO
Controlling EVAstream by piëzo without APP
Rotary switches at 701
Slow down and speed up in 10% increments
See wiring schematic Piezo3 to SP/EVA-ECA-PRO
Controlling EVA Lighting by piëzo without APP
Rotary switches at 801
See wiring schematic Piëzo3 to SP/EVA-ECA-PRO
Rotary switch 3 (0-9)
Rotary switch 2 (0-9)
Rotary switch 1 (0-9)
Slave mode: External master Control (DMX advanced controller) *
Rotary switches at 005, DMX addresses EVAstream 5 and 6
When using a DMX advanced controller as master, use DMX start address 5.
Piëzo 2 = pass / pause DMX signal (note! the turbine pauses, but the scene continues in the DMX master)
Piëzo 1 = slow down
Piëzo 3 = speed up to maximum speed of the chosen scene (f.e. scene 70% : the maximum speed in this scene is 70%).
DMX master and no piëzo / start-stop switch in the pool? Place a bridge over SW/SW Piezo2.
1 dmx termistor
2 wifi: turn on for installation
Turn off immediately after installation
How the lamp groups are divided:
DMX 001 group 1 = underwater lighting (always responding to training)
DMX 011 Group 2
DMX 021 Group 3
DMX 031 Group 4
Summary of Contents for EVA-PIEZOSQ3-AMB-X
Page 4: ...Wiring Diagrams V22 3 4...
Page 6: ...Wiring Diagrams V22 3 6...
Page 11: ...Wiring Diagrams V22 3 11...
