Eurotherm 605 Series, Product Manual Installation & Instructions

Page: 155 / 221

Routine Maintenance and Repair
8-1
605 Series Frequency Inverter
8
R
OUTINE
M
AINTENANCE AND
R
EPAIR
Routine Maintenance
Periodically inspect the Inverter for build-up of dust or obstructions that may affect ventilation of
the unit. Remove this using dry air.
Repair
There are no user-serviceable components.
IMPORTANT: MAKE NO ATTEMPT TO REPAIR THE UNIT - RETURN IT TO EUROTHERM DRIVES.
Saving Your Application Data
Although the Inverter retains saved settings during power-down, it would be wise for you to keep
your Operator Station. If your last SAVE TO OP function was made on this unit before the fault
occurred, then the Operator Station will still hold your application data. You can transfer this
back into the repaired unit, if necessary. You may, depending upon your knowledge of the fault,
attempt the back-up of your application data now, refer to Chapter 5: “The Operator Station” -
Copying an Application.
If the fault clearly lies within the Operator Station, then return it for repair.
Returning the Unit to Eurotherm Drives
Please have the following information available:
•
The model and serial number - see the unit’s rating label
•
Details of the fault
Contact your nearest Eurotherm Drives Service Centre to arrange return of the item.
You will be given a Returned Material Authorisation. Use this as a reference on all paperwork
you return with the faulty item. Pack and despatch the item in the original packing materials; or
at least an antistatic enclosure. Do not allow packaging chips to enter the unit.
Disposal
This product contains materials which are consignable waste under the Special Waste
Regulations 1996 which complies with the EC Hazardous Waste Directive - Directive
91/689/EEC.
We recommend you dispose of the appropriate materials in accordance with the valid
environmental control laws. The following table shows which materials can be recycled and
which have to be disposed of in a special way.
Material
Material Material
Material Recycle
Recycle Recycle
Recycle Disposal
Disposal Disposal
Disposal
metal yes no
plastics material yes no
printed circuit board no yes
The printed circuit board should be disposed of in one of two ways:
1. High temperature incineration (minimum temperature 1200
°
C) by an incinerator authorised
under parts A or B of the Environmental Protection Act
2. Disposal in an engineered land fill site that is licensed to take aluminium electrolytic
capacitors. Do not dispose of in a land fill site set aside for domestic waste.
Packaging
During transport our products are protected by suitable packaging. This is entirely
environmentally compatible and should be taken for central disposal as secondary raw material.