100 MM GRAPHICS RECORDER: USER GUIDE
HA027271
Issue 12 Mar 04
User Guide
Page 110
B3.2 Maintenance schedule
Battery replacement - Every three years
B3.3 Battery replacement procedure
Notes:
1.
The battery is of poly-carbonmonofluoride/lithium construction and should be disposed of accord-
ing to local regulations covering this type of battery.
2.
It is recommended that the recorder be isolated from mains (line) power before the battery is re-
placed. All battery backed RAM data is lost during battery change.
1.
Remove the mains connector. For convenience, disconnect the relay and Ethernet connectors (if fitted).
2.
Remove the rear terminal cover (A) by pressing down on the catch and lifting off. Remove the input connector
(B), by pressing-in on the end clips and pulling on the connector (figure B3.2a).
3.
Remove the three screws 'C' in figure B3.2b.
4.
Carefully lift the front of the recorder case cover, and disconnect the two looms connecting it to the internal cir-
cuit board (figure B3.2c)
5.
Push the battery out of its holder as shown in figure B3.2d.
6.
Instal the new battery by pushing it into position (+ uppermost).
7.
Re-connect the two looms previously disconnected, then re-assemble the recorder.
Figure B3.2a Remove terminal cover and connector
Figure B3.2b Release cover plate
Figure B3.2c Disconnect looms; Remove cover plate
Figure B3.2d Replace battery
C
C
C
B
A
Battery type: BR2330
Part Number: PA261095
