29
Mnemonic
Scrolling Display and description
Range
SS.PWR
SOFT START POWER LIMIT
This parameter only appears if the timer
configuration is set to
sfst
(Softstart). It sets a power limit which is
applied until the measured temperature reaches a threshold value
(SS.SP)
or the set time
(DWELL)
has elapsed. The timer starts
automatically on power up.
-100 to 100%
SS.SP
SOFT START SETPOINT
This parameter only appears if the timer
configuration is set to
sfst
(Softstart). It sets the threshold value
below which the power is limited.
Between SP.HI and SP.LO
DWELL
SET TIME DURATION
– Sets the dwell timing period. It can be
adjusted while the timer is running.
0:00 to 99.59 hh:mm: or
mm:ss
T.REMN
TIME REMAINING
Timer time remaining. This value can be increased
or decreased while the timer is running.
0:00 to 99.59 hh:mm: or
mm:ss
This section applies to Alarms only
If an alarm is not configured the parameters do not appear
A1.--- - to
A4.---
ALARM 1 (2, 3 or 4) SETPOINT
Sets the threshold value at which an
alarm occurs. Up to four alarms are available.
The last three characters in the mnemonic specify the alarm type:
HI = High alarm, LO = Low alarm
DHI = Deviation high, DLO = Deviation low BND = Deviation band
alarm
SP.HI to SP.LO