16
Data
Value
U .M
Power supply type
230-1-50
V-ph-Hz
Cable supplied
1 .5
m
Plug type
Schuko
type
Protection required
16
A
GENERAL INFORMATION
UNIT ELECTRICAL CONNECTION
SOLAR SYSTEM ELECTRICAL CONNECTION (SOL VERSION)
The units are supplied with a cable with plug as shown in the wiring diagrams supplied with the machine . The power
plug is a Schuko type with earth . All the electrical components inside the unit, including the electrical heating element,
do not require additional connections .
The electrical connection is made by plugging the unit into a power socket .
N.B.: The socket for the power cable must have an approved earth and meet the requirements given in the technical
data table .
The plug must be accessible at all times .
The cable supplied is 1 .5 m long . Make sure there is a power socket near the place chosen for installation .
The unit's electronic controller can manage the components necessary
for operation of a solar circuit . For the electrical connection of these
components it is necessary to access the terminal blocks inside the upper
shell of the unit .
To do this, the cover of the unit must be removed .
Make sure to unplug the unit beforehand .
For this operation proceed as follows .
1)
Remove the 4 screws on the front panel
2)
Remove the panel, disconnecting touch screen terminal
3)
Remove the cover screws
4)
Remove the cover
5)
Remove the electrical box cover screws
6)
Make connections as shown in the wiring diagram supplied .
7)
Refit everything
ELECTRICAL CONNECTIONS
Fig .2
Fig .3
