EUROSTER 11WB
–
USER MANUAL
3
Caution! Failure to meet the above requirements may result in malfunction of
the thermal protection.
Caution! The voltage of the cable is 230 V. In case of damage to the cable or its
extension make sure to disconnect power supply from the controller.
Ambient temperature in a place of the controller installation should not exceed
40
°C.
6.
DISPLAY DESCRIPTION
Active elements of the display are presented below:
1.
Name of the set parameter
–
displayed while previewing or changing the setting
2.
Boiler temperature sensor icon
3.
Manual operation mode icon
–
lit while the temperature is manually adjusted
4.
Alarm icon
–
blinks in case of alarm
5.
Furnace status display
–
see the description below
6.
Blower icon
–
lit at the time of blower operation
7.
DHW pump icon
–
lit at the time of pump operation
8.
CH pump icon
–
lit at the time of pump operation
9.
Tank temperature / Menu item number
10.
Boiler temperature / Value of the displayed parameter
11.
DHW tank temperature sensor icon
12.
“DHW priority” operation mode switch
-on icon
The furnace status is displayed in the form of animation.
Firing-up
–
the boiler has not yet reached its preset temperature:
->
->
->
Operation
–
the furnace temperature is near to the preset (within the hysteresis range):
<->
Blow-throughs
–
the furnace temperature has exceeded the preset by more than at least a half
of the hysteresis value