Document ID:06080001
Rev: B
Technical Support: 800-626-6912
Page 20 of 24
Removal / Replacing Jet Parts
Tools required:
Pliers
7/8" deep well socket with extension
Check your state and local regulations for cleaning procedures. Links to your state boards can be
found on our web site, at www.europeantouch.com. Refer to the cleaning procedure page headed
“Traditional Whirlpool
(With Jets)
- Spa Cleaning and Disinfecting Procedures,” page 19, for cleaning
recommendations.
Follow the steps below for cleaning and replacing parts:
Step 1:
Remove the jet eyeball using the pliers. Pull
forward with a quick tug.
Step 3:
Remove the jet nozzle and nut using a
7/8"
deep-well socket and extension.
Step 2:
Remove the adjusting cover. This should pull
out.
Step 4:
For cleaning, refer to “Traditional Whirlpool
(With Jets)
- Spa Cleaning and Disinfecting
Procedures”
on page 19. Reassemble the jet
assembly. The jet nozzle nut should be hand
tightened using the socket with extension. If the
adjustment cover is hard to turn, slightly loosen the
jet nozzle nut.
Step 5:
Reverse steps to reassemble.
Removal / Replacing Suction Cover
Tools required:
Philips head screwdriver
Check your state and local regulations for cleaning procedures. Links to your state boards can be
found on our web site, at www.europeantouch.com. Refer to the cleaning procedure page headed
“Traditional Whirlpool
(With Jets)
- Spa Cleaning and Disinfecting Procedures,” page 19, for cleaning
recommendations.
Follow the steps below for cleaning and replacing parts:
Step 1:
Unscrew Phillips head screw, located in the
center of suction cover, turning counter clockwise.
Step 2:
Pull cover forward to remove.
Step 3:
For cleaning, refer to “Traditional Whirlpool
(With Jets)
- Spa Cleaning and Disinfecting Procedures” on
page 19.
Step 4:
Put cover back on and replace Phillips head screw turning clockwise.
Caution: Do not over tighten screw.
Clean this area, using low
foaming soap and
disinfectant, with a brush.
Remove all visible
residue and rinse with
clean water.
Clean this area, using
low foaming soap and
disinfectant, with a
brush. Remove all
visible residue and
rinse with clean water.
