Document ID:06080001
Rev: B
Technical Support: 800-626-6912
Page 21 of 24
Removing / Replacing Drain Handle
Tools required:
Phillips head screwdriver
Check your state and local regulations for cleaning procedures. Links to your state boards can be
found on our web site, at www.europeantouch.com. Refer to the cleaning procedure page headed
“Crystal Clean™ Pipe-Free
®
Spa - Cleaning and Disinfecting Procedures,” page 17, and “Traditional
Whirlpool
(With Jets)
- Spa Cleaning and Disinfecting Procedures,” page 19, for cleaning
recommendations.
Follow the steps below for cleaning and replacing parts:
Step 1:
To remove the chrome handle pull it
forward. If difficult to remove, gently pry it
off with the screwdriver.
Step 3:
Picture, with the adapter removed,
shown for cleaning reference.
Step 2:
To remove the handle adapter, place
Phillips head screwdriver into upper slot to
reach screw, as shown in picture above.
Unscrew and then pull adapter forward.
Step 4:
Picture, with Drain Plunger removed,
shown for cleaning reference.
Removing / Replacing Impeller
Check your state and local regulations for cleaning procedures. Links to your state boards can be
found on our web site, at www.europeantouch.com. Refer to the cleaning procedure page headed
“Crystal Clean™ Pipe-Free
®
Spa - Cleaning and Disinfecting Procedures,” page 17, for cleaning
recommendations.
Follow the steps below for cleaning and replacing parts:
Step 1:
Remove the Tee Knobs
by turning counter
clockwise.
Step 3:
Unscrew to remove the
impeller knob.
Step 5:
Complete steps 1
through 4 in reverse to
replace the parts.
Step 2:
Lift the footplate to
remove.
Step 4:
Lift the impeller.
Step 6:
Press firmly down on
footplate to help seal while
tightening Tee Knobs.
