Document ID:06080001
Rev: B
Technical Support: 800-626-6912
Page 11 of 24
Specifications
Hot and cold water supply lines required
(hot and cold shut offs may be installed under pedicure spa
base) See pages seven through ten.
Drain installation:
references noted on pages seven through ten, can be installed with
optional power drain pump or as gravity drain.
Overall dimensions without accessories, seat upright:
54"L (138cm) x 31"W (82cm) x 56"H
(143cm)*
Without accessories, seat collapsed:
(shipping position): 54"L (138cm) x 32"W (82cm) x 36"H
(92cm)*
Shipping dimensions:
55"L (140cm) x 33"W (87cm) x 41"H (108cm)*
Empty weight:
150 Ibs (68kg)*
Shipping weight:
205 lbs (92kg)*
Capacity of basin:
5 U.S. Gallons = Traditional Whirlpool
(with Jets)
*
6.5 U.S. Gallons = Crystal Clean
™
Pipe-Free
®
*
Whirlpool pump motor:
1/6 HP, 110V, 60HZ (alternate voltages available) (3/4 HP for Traditional
Whirlpool -
with Jets
)
Forte’ seat and back motors:
30V DC Linear Actuators. Forte’ requires 18” (46 cm) of space between
pedicure spa and wall with standard actuator, and 24" (61 cm) with fully-
reclining actuator.*
Altera seat and back movement:
2 infinitely adjustable lockable gas cylinders for reclining/sliding.
The Altera requires 12" (31cm) of space between pedicure spa and wall
in order for seat to recline to its fullest extent.*
Massage motor:
12V AC, Adapter included (alternate voltages available)
Power source:
110V AC/ 5 Amp, 60 Hz (GFCI Protected)
Caution: Pedicure spa must be installed by a licensed electrician and a licensed
plumber, conforming to all local and national electrical codes.
Construction:
Linear Low Density Polyethylene (LLDPE), self-contained, pre-plumbed
Crystal Clean
™
Pipe-Free
®
water massage system (pipe-free
pedicure spas):
'underfoot' footplate
water massage grooves, no closed loop circulating pipes, 100% fully
drained, and cleanable
Hydro-Therapeutic (Jet System: Traditional Whirlpool pedicure spas):
PVC, two (2) fully-
directional jets, built-in air control
Electrical switches:
On/Off switch for whirlpool pump. Hand-held low voltage remote controls
for massage motors, heat and seat/back position hot and cold water
supply lines required
UL listed/CE certified:
Complies with ASME/ANSI Whirlpool Bathtub Specs ASME/ANSI
A112.19 7M-1995 and A112.19.8M-1995. Backflow Protection Devices
for Faucets with Side Spray: Check valves comply with ANSI/ASME
A112.18.3M, A112.18.1M, and CSA B125.
Limited warranty:
One (1) year from date of purchase.
Due to our policy of continuous improvements, all specifications are subject to change without notice.
*Note: All dimensions and weights are approximate
