17
JVF-M2 Series Outdoor Gas Fireplace
IGM2S-190417
TRIM and FINISH
INSTALLING THE WALL PANELS
The
J Series Outdoor Gas Fireplace
is shipped with two stainless steel wall panels. One to cover the
fireplace controls and one decorative. These panels have a metal stud protruding from the top end of the
panel. This stud should be inserted into the locator holes located on the ceiling of the fireplace at either end.
INSTALLING THE LIGHT COVERS
On the single sided models, install the clear glass in the back light area by laying it on the two angle brackets
to cover the back light only, centered on the LED lights.
On the see through models, install the clear glass in both light areas by laying it on the protruding studs
located on the reflector panels to cover light. Make sure the clear glass is centered on the LED lights. Clear
glass must be used.
After the clear glass has been laid down, install the frosted glass which should lie parallel to the burners,
covering the lights to hide them.
INSTALLING THE GLASS CAPTURE PANELS
After the installation of the frosted glass panels, install the glass capture panels between the end of the
burner and wall panels. The lip of the glass capture panel should be installed under the lip of the burner.
Secure using (2) supplied pan head screws
INSTALLING OPTIONAL WIND GUARD
A wind guard is standard for single sided models. See through models do not have a wind guard.
1.
Install wind guard bracket to glass capture panel at each end of the burner, using the supplied
phillips head screws.
2.
Slide wind guard glass into channel carefully, making sure to fully seat the glass into the bottom of
the channels to make sure there is a secure and tight fit.
