Euromag EUROSONIC 2000 HH, User Manual

Page: 31 / 80

EUROMAG | 31
Menu window No.
M34
M35
M36
M37
M38
M39
M40
M41
M42
M43
M44
M45
M46
M47
M48
M49
M50
M51
M52
M53
M54
M55
M56
M57
Function
Turn on or turn off the NET totalizer
Turn on or turn off the POS totalizer
Turn on or turn off the NEG totalizer
(1) Totalizer reset
(2) Restore the factory default settings. Press the
key followed by the key.
Attention, it is recommended to make notes on the parameters before doing the
restoration.
Manual totalizer used for calibration. Press any key to start and press the key again to stop
the totalizer.
Language selection, Chinese or English.
Flow rate damper setup. The damping parameter ranges from 0 to 999 seconds.
0 means there is no damping. Factory default is 10 seconds.
Zero flow rate (or low flow rate) cut-off to avoid invalid accumulation.
Zero point setup. Make sure the liquid in the pipe is not running while doing this setup.
Clear the zero point value, and restore the factory default zero point.
Set up a flow bias. Generally this value should be 0.
Flow rate scale factor. The factory default is ‘1’.
Keep this value as ‘1’ when no calibration has been made.
Network address identification number (IDN). Any integer can be entered except 13(0DH,
carriage return), 10 (0AH, line feeding), 42 (2AH), 38, 65535.
Every set of the instrument in a network environment should have a unique IDN. Please refer
to the
chapter for communications.
System lock to avoid modification of the system parameters
Not used
Window for network communication test
Window to set up the schedule-based data saving. Select the items to be saved.
Window to set up the schedule for the schedule-based data saving
Data output direction control.
If ‘To RS-232’ is selected, all the data will be directed to the RS-232 interface
If ‘To buffer ‘ is selected, the data will be stored into the built-in logger memory
Allow user to clear data buffer
Logger buffer viewer. It functions as a file editor. Use
, , and keys to browse
the buffer.
If the logger is ON, the viewer will automatically refresh once new data are stored
Not used
Nod used
Not used
Not used
MENU WINDOWS DETAILS