00092677.DOC, Version 1.0
25/28
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
Addressing
The device has two different DMX channel modes. The Control Board allows you to assign the DMX starting
address, which is defined as the first channel from which the LED TMH-13 will respond to the controller.
If you set, for example, the address in the 11 channel mode to channel 12, the device will use the channel 12
to 22 for control.
Please, be sure that you don’t have any overlapping channels in order to control each LED TMH-13 correctly
and independently from any other fixture on the DMX-chain.
If several LED TMH-13 are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
TMH-13 via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the display will show
"A.001"
with the actually set address. If there is no data received at the
DMX-input, the display will show
"A001"
with the actually set address.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
DMX-protocol
Mode/
Channel
Decimal Hexad. Percentage
S
/F
Feature
9 CH 11 CH
1 1
Horizontal movement (PAN)
0
255 00 FF 0%
100% F
Push slider up in order to move the head horizontally
(PAN). Gradual head adjustment from one end of the slider
to the other (0-255, 128-center). The head can be stopped
at any position you wish.
2
PAN-movement with 16-bit resolution
0
255 00 FF 0%
100% F Fine indexing
2 3
Vertical movement (TILT)
0
255 00 FF 0%
100% F
Push slider up in order to move the head vertically (TILT).
Gradual head adjustment from one end of the slider to the
other (0-255, 128-center). The head can be stopped at any
position you wish.
4
TILT-movement with 16-bit resolution
0
255 00 FF 0%
100% F Fine indexing
3 5
Color-wheel
0
9 00 09 0%
4%
S Open/White
10
19 0A 13 4%
7%
S Red
20
29 14 1D 8%
11% S Green
30
39 1E 27 12%
15% S Blue
40
49 28 31 16%
19% S Yellow
50
59 32 3B 20%
23% S Light blue
