EuroLite LED MFX-10 Beam Effect, User Manual

Page: 33 / 42

00105768, Version 1.0 33/42
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received at the DMX-input, the display will not blink. If there is no data received at the DMX-input, the
display will blink.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective,
- the cable or connector is defective or the signal wires are swap in the input connector.
DMX-protocol
The device has four different DMX channel modes. The Control Board allows you to assign the DMX channel
mode.
6-Channel Mode
Channel: Value: Function:
1
Master Dimmer
000 – 255 Increasing intensity (0 – 100%)
2
Strobe
000 – 255 Increasing speed
3
Movement
000 – 007 No function
008 – 022 Movement 01
023 – 037 Movement 02
038 – 052 Movement 03
053 – 067 Movement 04
068 – 082 Movement 05
083 – 097 Movement 06
098 – 112 Movement 07
113 – 127 Movement 08
128 – 142 Movement 09
143 – 157 Movement 10
158 – 172 Movement 11
173 – 187 Movement 12
188 – 202 Movement 13
203 – 217 Movement 14
218 – 232 Movement 15
233 – 247 Reset
248 – 255 Sound control
4
Geschwindigkeit
000 – 255 Increasing speed of the TILT-movement
5
Farb-Chasers *
000 - 014 No function
015 - 255 Chaser programs
6
Geschwindigkeit
000 – 255 Increasing speed of the Chaser programs
* = Please see the tables at the end of the DMX Protocol for color presets and chaser programs.