00105768, Version 1.0
31/42
Lighting effects must not be connected to dimming-packs.
The device is equipped with a lockable power input connector. Plug in the power cord and turn it to the right
until it locks. Plug the power cord into a grounded electrical outlet that matches the rated voltage of the
machine.
Connection between devices
On the rear panel, there is a socket (Power Out). Connect the output with the mains input of the next fixture
until all fixtures are connected.
Please note:
A maximum of 8 devices may be linked together. After every 8 devices, the fixtures
must have a renewed connection with the power mains.
OPERATION
After you connected the effect to the mains, the LED MFX-10 Beam Effect starts running. During the Reset,
the motors are trimmed and the device is ready for use afterwards.
The display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the Control Board or in
DMX-controlled mode via any commercial DMX controller.
Stand-alone operation
In the Stand-alone mode, the LED MFX-10 Beam Effect can be used without controller.
Disconnect the LED MFX-10 Beam Effect from the controller and call up the internal programs. Please refer
to the instructions under
Control Board
.
Control Board
The Control Board offers several features: you can easily set the starting address or run the pre-
programmed program.
Press MODE to access the menu on the display. Browse through the main menu by pressing UP or DOWN.
Press ENTER in order to select the desired menu. You can change the selection by pressing UP or DOWN.
Press ENTER in order to confirm. You can leave every mode by pressing MODE. The functions provided are
described in the following sections.
Menu
Sub menu
Function
DMX address
DMX Address (001-512)
Setting starting address (001 - 512)
Channel mode
6/19/29/32 CH
Setting DMX channel mode
Slave mode
DMX
Setting Master or Slave Mode
Master
Slave 1
Slave 2
AutoRun mode
Auto 0—16
Internal programs
Speed 1—9
Increasing speed of the programs, Pan- and Tilt-
movements
Show mode
Show 0-16
Show-programs
Sound state
On/off
Sound control
Sound sense
0-100
Increasing sensitivity
Summary of Contents for LED MFX-10 Beam Effect
Page 1: ......
Page 41: ...00105768 Version 1 0 41 42 610 mm 235 mm 215 mm ...
