00105768, Version 1.0
32/42
Back light
On/off
Display turn off
On - Display always on
Off - Shuts off the display after a few seconds
Pan Inverse
No/Yes
PAN-Reverse
Tilt Inverse
No/Yes
TILT- Reverse
Auto Test
Testing
Test function
Fixture Time
Fixture work hours 0--9999
Fixture running time in hours
Firmware version
Ver
Reset
Reset
DMX-controlled operation
You can control the projectors individually via your DMX-controller.
The device has six different DMX channel modes.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED MFX-10 Beam Effect will respond to the controller.
If you set, for example, the address in the 29 channel mode to channel 50, the device will use the channels
50 to 78 for control.
Please, be sure that you don’t have any overlapping channels in order to control each LED MFX-10 Beam
Effect correctly and independently from any other fixture on the DMX-chain.
If several LED MFX-10 Beam Effects are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
MFX-10 Beam Effect via your lighting controller.
The individual channels and their features are listed under DMX-protocol.
UP DOWN ENTER
MODE
MIC
LED MFX-10
Beam effect
1
2
3
4
5
The LEDs of the device are arranged in the following order (see graphic) and can be individually controlled
with the following DMX-protocol.
Summary of Contents for LED MFX-10 Beam Effect
Page 1: ......
Page 41: ...00105768 Version 1 0 41 42 610 mm 235 mm 215 mm ...
