00100653.DOC, Version 1.0
35/44
rear side of the remote control press the small bar with the groove to the right and at the same time
remove the battery support. For operation, one 3 V button cell type CR2032 is required. When inserting,
pay attention that the positive pole of the button cell shows upwards in the support.
CAUTION!
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
not be disposed of with regular domestic waste!
Control via IR remote
The Controller has several buttons with following functions:
Brightness up
Brightness down
OFF
ON
R
ed
G
reen
B
lue
W
hite
100% R + 24% G
90% G + 23% B
22% R + 87% B
50% / 100% power
100% R + 47% G
82% G + 46% B
48% R + 75% B
Strobe effect
100% R + 71% G
72% G + 69% B
67% R + 62% B
Color Fading
100% R + 100% G
100% G + 100% B
100% R + 100% B
Color Switching
The device features a memory function. The last program selected will begin anew when the device is
restarted.
DMX-controlled operation
You can control the device individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
QuickDMX
Connect the transmitter to the DMX controller. Set each transmitter and the AKKU UP-1 QCL Flex Spot
QuickDMX into operation. Switch the function switch (QuickDMX) to ON.
The QuickDMX status indicator shortly flashes red, green and blue. Afterward, it lights permanently
according to the selected transmission channel.
Set each transmitter and receiver to the same transmission channel. For this purpose, shortly press the
button ID SET on the device.
The selected transmission channel is indicated by the status indicator.
Channel Color
1
Red
2
Green
3
Blue
4
Yellow
5
Cyan
6
Magenta
Thus, the wireless DMX network is set up and the receivers are paired to the transmitter. The assignment of
the receivers to the transmitter is kept memorized even after disconnecting the power supply.
As soon as the transmitter receives a DMX signal, the status indicator switches to red. Shortly afterward, the
status indicators of the receivers start flashing green to indicate that the DMX signal is being received. The
DMX-controlled units can now be controlled via radio.
After the operation, disconnect the mains plug of the power supply unit from the mains outlet, to prevent
unnecessary power consumption.
Summary of Contents for AKKU UP-1 QCL
Page 43: ......
Page 44: ...AKKU...
