00100653.DOC, Version 1.0
30/44
DANGER OF FIRE!
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
CAUTION!
Use 1 appropriate clamp to rig the fixture on the truss.
Make sure that the device is fixed properly! Ensure that
the structure (truss) to which you are attaching the fixtures is secure.
The device can be placed directly on the stage floor or rigged in any orientation on a truss without altering its
operation characteristics.
Mount the device to your trussing system using an appropriate clamp. Use a clamp with M10.
In order to lock the device in any desired position, you need, depending on the clamp used,
an additional
circlip for installation. Screw the clamp via a M10 screw, a circlip and a nut onto the mounting thread.
For overhead use (mounting height >100 cm), always install an appropriate safety bond.
You must only use safety bonds and quick links complying with DIN 56927, shackles complying with DIN EN
1677-1 and BGV C1 carbines. The safety bonds, quick links, shackles and the carbines must be sufficiently
dimensioned and used correctly in accordance with the latest industrial safety regulations (e. g. BGV C1,
BGI 810-3).
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Install the safety bond by inserting the quick link in the safety bond hole. Pull the safety bond over the
trussing system etc. Insert the end in the quick link and tighten the fixation screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already held the strain of a crash or which is defective must not be used again.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
Screw a clamp via a M10 screw and self-locking nut onto the Omega-holder.
Insert the screw of the Omega-holder into the respective holes on the bottom of
the device. Tighten the screws fully.
Changing the beam angle
With the delivery of the device you receive a lens with which the beam angle
can be changed from about 9° to about 15°. To change the beam angle of the device, attach the lens via the
union nut, attached to the lens. Make sure that the union nut is securely tightened to prevent accidental
loosening of the lens.
Summary of Contents for AKKU UP-1 QCL
Page 43: ......
Page 44: ...AKKU...
