14. Alarm
Alarms notify you if currently measured values exceed or fall below preset threshold values.
Trigger parameter pairs such as (lower outdoor temperature, upper outdoor temperature) can
be individually enabled and disabled.
Only weather station and channel 1 are supported for alarms.
a) Set trigger parameter
Note the display icons:
LOW
for lower value /
HI
for upper value
Trigger parameter
Trigger threshold
Alarm icon
Snoozable
Hour / Minute (Alarm clock)
Alarm time
Yes
Outdoor temperature
Outdoor humidity
Dew point
Indoor temperature
Indoor humidity
Absolute pressure
Relative pressure
exceeds upper value
No
falls below lower value
No
1. Press the
SNOOZE/LIGHT
button to enter normal mode.
2. Press and hold the
ALARM
button for approx. 3 seconds to enter alarm mode.
- If no user input is registered for 30 seconds, the display enters normal mode again.
3. Press and hold the
SET
button until the hours of the clock flash.
4.
Repeatedly press the
SET
button until you reach the trigger parameter for which you like
to be notified.
5. Press the
HISTORY/–
or
C
buttons to set the trigger thresholds (e.g. upper
temperature and lower temperature).
6. Press the
ALARM
button to activate the alarm for the trigger threshold (upper/lower). The
corresponding alarm icon shows on the display next to the measured/displayed value.
- Press the
ALARM
button again to deactivate the alarm for the trigger parameter. The
alarm icon fades out from the display.
7. Press the
SET
button to go to the next trigger parameter.
59
