www.euroboor.com
19
4.2 Turning off the Power Station
When you are finished working with the Power Station, it can be turned off completely. For turning off
the Power Station safely, follow steps below.
1.
Wait until the connected Power Tool has come to a complete stop.
2.
Then unplug the Power Tool from the Power Station. Do not pull the cord.
3.
Once the Power Tool is disconnected, turn off the Power Station by switching the On- / Off-
switch to the “Off” position.
4.
If the Power Station needs to be charged, refer to Paragraph 4.3.
4.3 Charging the Power Station
The Power Station needs to be charged after use. For charging the Power Station safely, follow steps
below:
NOTE:
The Power Station has a LED indicator ‘Caution’. This will light up when battery percentage is
low while working. When you are working and this light turns on, charge your Power Station. You can
also check the battery percentage in the screen in the middle of the panel plate.
NOTE:
It is strictly prohibited to use other chargers to charge our battery packs! It is also strictly
prohibited to use our chargers to charge other battery products. This both will result in hazardous
situations.
WARNING:
Only use the charger indoors.
1.
Before charging the Power Station, make sure the switch is in ‘OFF’ position.
2.
Plug in the charger’s output cable to the Power Station’s charging port.
3.
Plug in the charger’s input cable to the Power source (220V).
4.
Now the Power Station will start charging. As long as the red LED indicator 'CHARGING' on the
charger is lit, the Power Station is not yet fully charged.
5.
The Power Station is fully charged when the green LED indicator 'FULLY CHARGED' lights up.
