www.euroboor.com
18
4. Using the Power Station
4.1 Turning on the Power Station
In order to access the power stored in the Power Station, it needs to be switched on. Please follow all
steps below to turn the Power Station on safely.
1.
Before turning on the Power Station it is important to check that it is positioned safe and
stable. If the Power Station is not positioned well, this increases the chances of accidents.
2.
Now you can press the on-/off- switch towards the ‘ON’ position.
3.
After pressing the switch to ‘ON’ position, the battery status will be shown on the Power
Station. Make sure the percentage shown on the screen is high enough to do the job.
4.
Now you can plug in the Power tool to the Power Station. The Power Station has two power
outlets. Make sure the total output of the two outlets does not exceed the Power Station’s
maximum output (3,000 W) nor its maximum short peek output (6.000 W).
NOTE:
The Power Station is equipped with an overload protection system. When the power of the
electric appliance exceeds the maximum output of the Power Station (3,000 W), it will stop the output.
Except for short peaks up to 6.000 W. When the power of the electric appliance is lower than the
maximum output of the Power Station, it will automatically recover.
WARNING:
Make sure the Power tool is in ‘OFF’ position when plugging it into the Power
Station.
5.
You can now use the Power tool. Briefly check the battery percentage every now and then, to
avoid unexpected fallout.
6.
When finished, refer to Paragraph 4.2 for turning off the Power Station, and Paragraph 4.3 for
charging.
