Euroboor ECO.30S+, User Manual

Page: 17 / 32

17
We want to point out that above mentioned precautions and indicators do not guarantee that the
magnet will not release from the material. Euroboor accepts no liability when it comes to the
magnet not functioning or functioning poorly.
Make sure that the magnet attaches tightly to the work piece before turning on the motor unit of the
magnetic drilling machine. Euroboor magnets have two coils; make sure that both coils are in contact
with the material. Do not connect any other machine to the same electrical outlet to which the
magnetic drilling machine is plugged into, as it may result in the loss of magnetic force.
Always use the safety chain included. Drilling above your head is extremely dangerous and is not
recommended. For the use of magnetic drilling machines on pipes, not-flat or non-magnetic
materials, we refer to our catalogue or our website www.euroboor.com where several vacuum
tightening systems, pipe clamping systems and tube machines can be found.
4.3 Switching motor on and off
The motor unit can only be switched ON when the magnet is activated. To switch the motor ON,
press the green button with marking “I”. To switch the motor OFF, press the red button with marking
“O”.
4.4 GYRO-TEC safety
This Euroboor magnetic drilling machine is equipped with GYRO-TEC safety functionality. It features a
gyroscopic sensor which detects acceleration and displacement in any direction. Whenever the
machine recognizes a sudden or unwanted movement the motor will be shut down automatically by
the machine’s electronics. This safety functionality offers protection to the user in various
circumstances, such as:
- Sudden loss of magnetic force while in operation;
- Excessive vibration caused by incorrect drilling procedure, worn-out cutting tools, etc;
- Sudden displacement of the workpiece to which the magnetic drilling machine is attached.
By the motor shutting down automatically, risk of damaging or hurting the machine, tools, workpiece
and operator is reduced.
Every time the motor is started, the machines electronics need a moment to run a systems check and
initiate the safety system. The GYRO-TEC safety feature engages three seconds after the motor is
started.
It is very important to note that this functionality raises the safety level, but does not prevent the
operator from using the machine incorrectly. The operator should always follow instructions
described in this manual and take all necessary safety precautions.
4.5 Power surge and fluctuation protection
This machine is equipped with power surge and fluctuation protection, making the machine suitable
for use in areas and workplaces where power supply is of less quality.