End
Cap Tab
Fig. 59
Brush Roll
End Cap
TROUBLESHOOTING
Fig. 55
Short
Belt
Motor
Shaft
Idler
Pulley
Brush Roll
Pulley
Fig. 56
9.
To remove the worn or broken long
belt from the idler pulley, lift the
brush roll and slide it out. (Fig. 54)
14
Fig. 54
16. Check to make sure that both belts
are completely centered on the
pulleys and printed sides are
outwards. and that the brush roll
turns smoothly.
17. Replace the belt cover and return
the carpet-to-floor selector to the
“Carpet” position.
18. Slide the power head cover over
the carpet-to-floor selector first
and then over the power head
base. Replace the screws.
IMPORTANT:
Make sure that you
DO
NOT
loop the short belt over the belt
guides. The short belt should go between
the idler pulley and the belt guides.
(Fig. 58)
13. Loop the new long belt over the
outside idler pulley and then over
the brush roll pulley.
14. Insert the left side of the brush roll
in first by placing the end cap down
into the slot.
15. Then insert the end cap of the right
side of the brush roll into the slot
and press to make sure that the tab
on the end cap snaps in place
securely. (Fig. 59)
Short Belt
Belt Guide
Idler Pulley
Fig. 58
12. Loop the new short belt over the
inside idler pulley and then over the
motor shaft. Make sure that the
arrows on the short belt are facing in
towards the motor. (Fig. 57)
Short Belt
Fig. 57
10. Located behind the long belt is the
short belt. If this belt is broken, it
needs to be replaced before
replacing the long belt. (Fig. 55)
11. Press the carpet-to-floor selector to
the “Bare Floor/Tools” position to
release the tension and then remove
the short belt from the motor shaft
and idler pulley. (Fig. 56)
APPRENEZ À CONNAÎTRE VOTRE BALAYEUSE CYCLONIC
VERTICALE
Spécifications Techniques
Voltage :
120V, 60Hz.
Alimentation :
12 A
Remarque : * Les illustrations peuvent différer du produit exact.
35
15. Tuyau Super Extensible
16. Suceur Plat
17. Brosse à Meubles
18. Brosse à Épousseter
19. Bouton de Dégagement du Bac à
Poussière
20. Port de Rinçage du Collecteur
Cyclone
21. Support du Tube Supérieur
22. Support de Dégagement Rapide du
Cordon d’Alimentation
23. Dégagement du Tube Télescopique
24. Support du Cordon d’Alimentation
25. Bouton Marche/Arrêt
26. Brosse pour Planchers
27. Brosse Puissante pour Poils
d’Animaux
1.
Poignée
2.
Tube Télescopique
3.
Poignée de Transport
4.
Bouton de Dégagement de la
Porte Inférieure du Collecteur
Cyclone.
5.
Collecteur Cyclone
6.
Bac à Poussière
7.
Écran de Débris
8.
Lumière d’Indicateur du Filtre
9.
Lumière
10. Bouton d’Ajustement de la
Hauteur du Tapis
11. Protège-Meuble
12. Déclencheur de Poignée
13. Sélecteur Tapis-à-Plancher
14. Support du Tube Inférieur
Summary of Contents for Shark Infinity NV31
Page 2: ......
