14
OPERATING EUROLCEAN STEEM
ATTACHMENT: UTILITY NOZZLE
For cleaning tiled surfaces, cabinets and worktops in kitchens and bathrooms. Also use
this attachment for cleaning upholstery, curtains, pillows and mattresses.
Use on a low to medium steam flow by adjusting the variable steam setting.
Cover the utility tool with one or two of the elasticated utility cloths.
ATTACHMENT: SPOT BRUSH
For cleaning the grout between tiles or stubborn marks and stains on hard surfaces. Use
at medium or high steam flow by adjusting the variable steam setting.
Apply gentle pressure. Too much force may damage the bristles. Two sets of spare bristles are supplied. To change, loosen
the screw and pull out the bristle set.
ATTACHMENT: DEFLECTOR NOZZLE
For cleaning sanitaryware such as toilet bowls, taps or drain covers. Use this nozzle at maximum steam flow. Point it directly at
temporary/short-lined/momentary stains on carpets or upholstery whilst holding a clean cloth, near the stained area, to
capture any loosened dirt.
SANITISING BEDDING AND UPHOLSTERY
•
To sanitise and remove dust mites and allergens from bedding and upholstery, fit the utility nozzle and pass the steam
slowly and evenly over the surface, ensuring all areas are treated. Repeat the process. Leave the mattress to dry
thoroughly before covering.
•
Sanitising surfaces and hard floor
•
To sanitize surfaces and hard floors, focus steam while cleaning or mopping for at least 15 seconds. Pass the steam
slowly and evenly over the surface, ensuring all areas are treated. Repeat the process.
Note:
When the steam cleaner is used for cleaning in the overhead position, increase the steam flow to maximum and allow
approximately 30 seconds for the steam to be generated in full. Now the flow can be reduced to the level required for the
particular accessory being used.
Note:
When using on hard/wooden floors, we recommend setting to minimum steam to prevent the floors from becoming too
wet. Use both forward and backward strokes across the floor area.
Summary of Contents for Euroclean Steem
Page 23: ...20...
